Hailo Libero 3.0 Montageanleitung Seite 17

2.1 Adding the Hailo Libero 3.0 to your home network
It is absolutely essential that you check and update the software version of your Libero 3.0 at
https://www.hailo.de/de/einbautechnik/p/hailo-libero-30-3697301
before connecting it to your home network. (For the procedure, see point 3.1)
Procedure for a new device:
- Plug in the power supply unit and wait until the light is permanently lit (this takes about 5 minutes).
To switch the WLAN on, press the Reset button (Fig. 1) for 1 second. The device will beep once.
-
- Search for the Libero 3.0 on your WLAN network settings and connect the devices to each other.
(The Access Point name is: Lib30_XXXXXX)
- The password for the Hailo Libero 3.0 is 0123456789.
- Once the devices are connected to each other, you can call up the login page of the Hailo Libero on your web browser (Edge, Firefox,
Chrome, etc.) via the IP address 192.168.4.1:81.
- The browser will then show the login page for your Hailo Libero. The password is hailo.
- If everything has been entered correctly, the web browser page will open automatically.
- Make the IP setting "Obtain automatically".
- In the next step, enter your network name and key.
- Finally, press "Save and restart".
- The device will restart. The LED will flash.
- Once the LED is permanently lit, the device has been added to your home network.
- The WLAN signal is now no longer visible in your network settings.
- The device can now only be accessed via the IP address allocated by your router.
2.2 Operating the Hailo Libero 3.0 by voice command (ALEXA)
- For it to be possible to open the Hailo Libero 3.0 by voice command, you must add the device to your home network.
(See the instructions "Adding the Hailo Libero 3.0 to your home network")
- As soon as the device has been added to your home network, you will be able to find it via ALEXA.
- To do so, you must search for the device via ALEXA.
- When the device has been found (ALEXA will say: I have found a new smart home device with the name "Lib30_XXXXXX"), we
recommend that you start by changing the name of the device from "Lib30_XXXXXX", => e.g. to rubbish bin, waste unit, or something
like that.
- Our Hailo Libero 3.0 communicates via the Philips HUE interface and normally listens to the commands ON and OFF, like a HUE
socket.
- To open the unit, say ALEXA_(your new device name)_ON
- To simplify things, you can also create a routine via ALEXA such as ALEXA_(your new device name)_OPEN.
- For details of how to create and use routines, please refer to the ALEXA manual.
Downloads, firmware update version 3.0.X
.
6