Guzzanti GZ-0824 Gebrauchsanleitung Seite 71

2. Very important:
2.1: The cooler will have better performance at ambient of 16-32 degree; We suggest
the cooler be powered off if the ambient temperature is lower than 10 degree.
2.2: After plugging the appliance, allow the unit to cool down for 2-3 hours before
placing beverage into the cooler compartment.
2.3: Ventilation is very important for this kind thermoelectric cooler; The inside PCB will
be broken easily if the ventilation is bad; It will also reduce the life of the cooler.
2.4: These models use a thermoelectric cooling system with automatic defrosting
system, so there is no need to defrost it manually.
3. Power supply:
3.1: The cooler must be connected to a properly earthed socket in line with relevant
valid country regulations before operating;
3.2: Check the data label (which is on the side of the cooler) for voltage and frequency
corresponds to your local one; If not, don't plug your cable into the socket;
VENTILATION
When putting a TE cooler, ventilation should be considered seriously, please refer to the
following:
1. there should be left at least 200 cm for ventilation
3
2. the distance between wall and cooler side should be at least 20mm
3. the back should be left at least 50mm for air flowing
4. air passing through must not be preheated
5. entire cooling system should be considered in the ventilation
7