Troubleshooting; Transportation, Storage And Disposal - Husqvarna A 1000 Bedienungsanweisung

Troubleshooting schedule
Problem
The fan does not start.
The fan stops immediately after
start of the product.
The fan is on but the suction is
low.
Dust blows from the product.
Unusual noise comes from the
product.
The indicator for replacement of
the prefilter lights up.
The indicator for replacement of
the prefilter stays on after the
prefilter is replaced.
The indicator for replacement of
the HEPA filter lights up.
Transportation of the product
• Always clean the product before transportation.
To clean the product on page 14 .
Refer to
• To prevent damages and accidents, make sure that
the product cannot move during transportation.
Storage of the product
• Before long-term storage make sure to do a
complete servicing and to clean the product. Refer
To clean the product on page 14 .
to
923 - 001 - 27.04.2022

Troubleshooting

Cause
The product has no power.
The cable is defective.
The On/Off button is defective.
The product is connected to the incorrect fuse.
The prefilter is blocked.
The HEPA filter is blocked.
The transportation cover is still on the product.
The fan is loose.
The prefilter is damaged or not assembled cor-
rect.
The HEPA filter is damaged or not assembled
correct.
The prefilter is full or damaged.
The HEPA filter is full or damaged.

Transportation, storage and disposal

Disposal of the product
• Obey the local recycling requirements and applicable
regulations.
• When the product no longer is used, send it to a
dealer or discard it at a recycling location.
Solution
Connect the product to a wall
outlet.
Replace the cable.
Replace the On/Off button.
Connect the product to the cor-
rect fuse.
Replace the prefilter.
Replace the HEPA filter.
Remove the transportation cov-
er.
Make sure the fan is in correct
position.
Adjust or replace the prefilter.
Adjust or replace the HEPA fil-
ter.
Speak to Husqvarna service
agent.
Replace the prefilter.
Replace the HEPA filter.
15