Werbung
Verfügbare Sprachen
Verfügbare Sprachen
G E N E R A L
This compressed-air supported tool is designed to extract oil from all current vehicle types via the oil
dipstick. By doing so, you do not need a car hoist to perform an oil change. For certain vehicle types
this tool is indispensable, because these vehicles are delivered without an oil bleed screw. Another
benefit of this tool is its built-in manual vacuum pump which allows venting brakes without compres-
sed-air. Just create a vacuum in the tools tank and vent the brakes as usual in a second step. Compres-
sed-air supported venting of brakes is also possible, of course.
N O T E S
•
Always wear fuel- and oil-resistant gloves when working with brake fluids.
•
Drawn off brake fluid has to be disposed properly and cannot be used again.
•
When using this pump for its various purposes (drawing off oil, venting brakes), assure that the-
re are no residual fluids in the pump's tank which will lead to a mixing of those fluids and a much
more difficult disposal.
M A N UA L
EXTRACTING OIL
1.
Get oil to working temperature.
2.
Seal compressed-air valve.
3.
Connect pump with compressed-air supply.
4.
Connect suitable extraction hose with pump hose.
5.
Push extraction hose through the dipstick until just before the ground of the oil pan, let
the guide wire in the oil suction tube
6.
Pull out the guide wire.
7.
Open compressed-air valve. Oil is drawn-off, now.
8.
If there is no more oil to be drawn-off, push the extraction hose deeper through the
dipstick. If no more oil can be drawn off, now, and the drawn off amount of oil matches
the recommended amount of oil (minus the content of the oil filter), then there is no
used oil in the oil pan.
9.
Seal compressed-air valve and pull out the extraction hose of the dipstick.
8
Werbung
