Technical Specifications; Parts List - JBM 60038 Bedienungsanleitung

Elektrofettfüller

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

REF. 60038

•

Set the speed adjustment wheel to a lower gear

for a lower output flow rate.

•

Set the speed adjustment wheel to a higher gear

for a higher output flow rate.

Rueda de ajuste del

Grease flow rate

adjustment wheel

caudal de grasa

Safety purge valve

The safety purge valve is set at the factory to relieve

pressure above 9000psi (620bar). Grease coming out

of this valve indicates a clog in the fitting, line or bea-

ring.

Válvula de purga

Safety purge valve

de seguridad

Using the grease gun

Hold the grease gun by the handle, or place it on

a stable surface upright on its rubber feet.

Holding the hose by the flexible hose safety

spring guard, connect the flexible hose grease

coupler or another appropriate grease coupler.

Carefully depress the variable speed trigger

switch.

Once the correct amount of grease has been

dispensed, release the trigger and remove the

coupler from the grease fitting.

MAINTENANCE

Always be sure that the tool is switched off and

the battery pack is removed from the tool before

attempting to perform inspection or maintenance.

Regularly clean the tool's air vents with compres-

sed dry air. Do not attempt to clean by inserting

pointed objects through openings.

Do not use cleaning agents to clean the plastic

parts of the tool, a mild detergent on a damp cloth

is recommended instead.

Dispose the recyclable li-ion batteries properly.

Blow dirt and dust out of all air vents with clean,

dry air at least once a week.

Cleaning contaminants from the check valve

Remove the check valve plug (BB), then the disc

(EE), spring (DD) and check valve ball (CC).

Clean the ball (CC) and the check valve area in

the main casting.

Reinstall the ball (CC), the spring (DD), and then

the disc (EE).

After all grease is cleaned from the area, reinstall

the check valve plug (BB).