Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ferguson Sp. z o.o.
BATTERY INSTALLATION
8.3
Remove the battery case cap on the back of the remote control by sliding the lid down,
then put it away. Insert two AAA batteries inside the container with the + and – poles
set as indicated.
FIRST INSTALLATION
9
CONNECT
9.1
NOTE! When connecting the receiver to
other equipment, e.g. TV, receiver. Make
sure
you
follow
instructions for use. Check that you have
disconnected all equipment from the main
power supply.
RUN
9.2
After the decoder connections to the rest
of the equipment are properly made, turn
on the set-top box and the remaining
hardware. If you first start or perform a
factory reset, a screen from the first
installation menu will appear. Using the
navigation keys of the remote control,
select the settings that are appropriate for
you.
Language – the OSD language is set
here
Country – this setting allows you to
specify scan parameters appropriate
for a given country in which the
device is installed
TV system – choice between PAL,
NTSC broadcasting systems
Resolution
–
resolution
Video
format
selection
(4:3
Pan&Scan, 16:9)
Antenna power supply – allows you
to choose between a powered or
passive antenna
Summer tim
LCN – sorting by terrestrial TV
provider numbering
FTA only – Allows you to filter paid
channels. FTA – "free to air"
After selecting the settings, go to the
"next" item and confirm with the "OK" key.
44
the
appropriate
choice
of
screen
–
image
format
Letter
box,
4:3
e – time setting
The signal from the antenna will be
scanned.
NOTE! Selecting a resolution or TV system
that is not supported by the TV may result
in a lack of video signal – the so-called
"black screen".
NOTE! Selecting a country other than the
one in which the device is installed may
result in the lack of reception of the full
range of channels due to differences in
signal parameters!
CONNECTING A SATELLITE
9.3
ANTENNA
In order to properly connect external
equipment m.in satellite antenna and
converter, please use the installation
instructions or the help of a professional
installer!
CONNECTION OF ANTENNA
9.4
INSTALLATION
TURNTABLE
The correct operation of the Ferguson
receiver is guaranteed by Stab's USALS
turntables. To connect the antenna system
with the USALS turntable, connect the
output from the turntable to the LNB IN
input of the Ferguson receiver. The task of
the turntable installed between the mast
and the antenna is to rotate the dish in
such a way that it directs to different
satellite positions.
CONNECTION OF A DIGITAL
9.5
TERRESTRIAL TV ANTENNA
The antenna should be directed to the
nearest broadcasting facility broadcasting
DVB-T digital television. Maps of the range
of individual transmitters in Poland are
available at: cyfryzacja.gov.pl
WITH
Werbung
Inhaltsverzeichnis
