Philips Airfryer L Connected HD9255 Bedienungsanleitung Seite 25

Problem
I see some peeling
off spots inside my
Airfryer.
White smoke
comes out of the
appliance.
The screen on the
Airfryer shows "E1".
The WiFi LED on
my Airfryer is not
shining anymore.
The App shows that
the pairing process
is not successful.
My display shows
blinking "---".
Possible cause
Some small spots can
appear inside the pan of
the Airfryer due to the
incidental touching or
scratching of the coating
(e.g. during cleaning with
harsh cleaning tools and/
or while inserting the
basket).
You are cooking fatty
ingredients.
The pan still contains
greasy residues from
previous use.
Breading or coating did
not adhere properly to
the food.
Marinade, liquid or meat
juices are splattering
in the rendered fat or
grease.
The device is broken/
defect.
Your Airfryer might be
stored in a place where it
is too cold.
The Airfryer is not
•
connected to your
home WiFi anymore.
You have changed your
•
home WiFi network.
Check whether you have
done the steps in the order
that is described in the
app: First push the button
on the appliance, then
activate pairing in the app.
Your Airfryer is updating
the firmware.
Solution
You can prevent damage by lowering the
basket into the pan properly. If you insert
the basket at an angle, its side may knock
against the wall of the pan, causing small
pieces of coating to chip off. If this occurs,
please be informed that this is not harmful
as all materials used are food-safe.
Carefully pour off any excess oil or fat from
the pan and then continue cooking.
White smoke is caused by greasy residues
heating up in the pan. Always clean the
pan and the basket thoroughly after every
use.
Tiny pieces of airborne breading can cause
white smoke. Firmly press breading or
coating to food to ensure it sticks.
Pat food dry before placing it in the basket.
Call the Philips service hot line or contact
the Consumer Care Center in your country.
If your device was stored at a low ambient
temperature, let it warm up to room
temperature for at least 15 minutes before
you plug it in again.
If your display still shows "E1", call the
Philips service hot line or contact the
Consumer Care Center in your country.
Repeat the pairing process in the order
described in the app. If it doesn't help, start
the setup process again.
Repeat the pairing process in the order
described in the app. If it doesn't help, start
the setup process again.
Wait for about one minute before the
firmware update process is finished.
You cannot use the Airfryer during the
firmware update.
ENGLISH
25