Installation Modes - IKEA SVAVANDE AA-2039860-10 Bedienungsanleitung

ENGLISH
Use
• Switch off or unplug the appliance
from the mains supply before carrying
out any maintenance work.
• The top of the hood must not to be
used as a shelf.
• The extractor hood has been designed
exclusively for domestic use to
eliminate kitchen smells.
• Never use the hood for purposes other
than for which it has been designed.
• Never leave high naked flames under
the hood when it is in operation.
• Adjust the flame intensity to direct
it onto the bottom of the pan only,
making sure that it does not engulf the
sides.
min 471 mm
Deep fat fryers must be continuously
max 861 mm
monitored during use: overheated oil can
burst into flames.

Installation modes

The hood has been designed to be
installed and used either as a "Exhaust
mode", or as a "Recirculation mode".
Exhaust mode (see symbol in
min 471 mm
installation booklet)
max 861 mm
min 471 mm
min 569 mm
Cooking steam is sucked and channelled
max 861 mm
max 861 mm
outside the house through a discharge
duct (not supplied), fitted to the hood
steam outlet.
Ensure that the discharge duct is correctly
fitted to the air outlet, unit using an
appropriate connection system.
Recirculation mode (see symbol
in installation booklet)
The air is filtered through one or more
min 569 mm
min 569 mm
max 861 mm
max 861 mm
the charcoal filters, and then resent into
room.
Important: Ensure appropriate air
circulation around the hood.
Important: If the hood is supplied
without charcoal filters and installed on
recirculation mode, these must be fitted
before the hood can be used. Filters are
available in shops.
The hood should be installed away from
particularly dirty areas, windows, doors
and heat sources.
The accessories for wall fixing are not
included because wall made of different
materials require different types of fixing
accessories. Use fixing systems suitable
for the walls of your home and the weight
of the appliance. For more details, contact
a specialized dealer.
Keep this booklet for future consultation.
Filters Alarm.
When the filter alarm is activated, the
following messages will appear over
time:
Grease filter must be cleaned:
"A" key flashes once per second. For
maintenance see paragraph Care and
cleaning.
Anti-odour filter must be cleaned:
"A" key flashes twice per second. For
maintenance see paragraph Care and
cleaning.
Once the filters have been regenerated
reset the alarm signal (see paragraph
Control Panel).
9
7