UNILITE HT-680R Bedienungsanleitung

FEATURES
• High power 680 lumen spot beam Cree LED, 6500k
• Secondary 500 lumen flood beam high CRI 90+ Cree LED, 4500k
• Memory Switch - remembers last mode used
• Super tough construction with rubberised coating
• Fully adjustable non-slip silicone lined headband
• 4 x Helmet clips included
• 90˚ rotational head
• IP65 dust & water resistant
• IK07 shock proof - 2m drop resistant
• Rechargeable 3.7v 2600mAh Li-ion battery
• Useful battery level and charging indicator
• Quick USB-C Charging - 4½ hour charge time
• 1m USB-C charging cable included
BATTERY - 3.7v 2600mAh Li-ion Rechargeable Battery
WEIGHT - 175g
DIMENSIONS - Headtorch: W56 x H35 x D25mm
Battery Pack: W86 x H36 x D37 mm
ADVICE & IMPORTANT INFORMATION!
ƒ Do not look directly at LEDs.
ƒ Do not operate in direct sunlight or extreme temperature conditions (below -20°C or
above 60°C).
ƒ LEDs can become warm/hot when switched on; do not touch and never place face
down on any surface – risk of fire!
ƒ Do not use the device if there is any visible damage.
ƒ Take care when using USB plug adaptors, check for any damage. Check the charging
output on the plug and DO NOT exceed the stated Max charging input or damage may
occur to the battery and may void the warranty.
ƒ The rechargeable battery will reach full performance after a few complete charging and
discharging cycles.
ƒ To keep the rechargeable battery in optimum condition, it should be recharged every
3-6 months, especially if it is not being used for a long period of time. Always fully
charge batteries before storage.
ƒ Always protect lithium batteries from heat, intense sunlight, fire, water and moisture –
danger of explosion!
ƒ If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin
irritation and/or burns. If skin contact occurs, rinse thoroughly with water. If irritation
persists, seek medical advice. Seek immediate medical assistance if lithium battery fluid
comes into contact with the eyes.
ƒ Children under 12 years of age should only use the product under adult supervision.
ƒ Do not open, disassemble or attempt to modify the product; this will void the warranty
and can be dangerous. Improper use or modification is not covered under the warranty.
ƒ Take care not to let lenses come into contact with hard/sharp objects, damage/
scratches to lenses will affect light output.
ƒ Do not use the product in the immediate vicinity of flammable materials or gases.
ƒ Before cleaning the product, disconnect the charge cable. Clean with a dry or slightly
moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
ƒ This product is water resistant to IPX5 – DO NOT SUBMERGE. If the product has been
subjected to excessive moisture/water the warranty may be void.
ƒ This product has a 1 year standard warranty (or extended to 2 years once registered
online at WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects.
It does not cover normal wear and tear, modifications, accidental damage or poor
maintenance. Unilite warranties do not cover disposable battery leaks or the use of
incorrect chargers and cables that can damage rechargeable batteries.
ƒ Do not dispose of this device in normal household waste. It must be disposed of via
an authorised electrical appliance disposal centre or at your local waste disposal unit.
ƒ Please re-use or recycle packaging responsibly where possible.
ƒ Keep these instructions for future reference or for subsequent possessors.
www.unilite.co.uk
ANSI FL1 Standard
Spot Beam
Spot & Flood
Flood - High
Flood - Mid
Flood- Low
OPERATION
Switch Sequence: SPOT BEAM > SPOT BEAM & FLOOD > FLOOD
LIGHT HIGH > FLOOD LIGHT MEDIUM > FLOOD LIGHT LOW > OFF
MEMORY FUNCTION:- If left ON in any mode for 5 seconds or more,
the next press will turn OFF. Next press ON will return to that last mode
used.
Cool white
Spot LED
CHARGING
1. Only use a 5V USB-C cable (max 1A).
2. Plug the USB-C end of the cable into the charge port on the
bottom of the battery pack.
3. Plug the USB-A end of the cable into a USB charging port (do not
exceed 5V-1A charging input or damage may occur).
4. Green flash indicates charging, Solid Green indicates fully charged.
5. Charge Time: 4½ hours
6. Make sure the charge port cover is secured back in place.
*Warranty void if not used with the specified cable & max charge input*
CHARGING INDICATOR
Green Flash = charging
Green = fully charged
BATTERY LEVEL INDICATOR
Battery indicator lights up for 10 seconds
when the headtorch is turned on.
Green = 65% - 100%
Orange = 30% - 65%
Red = 5% - 30%
Red Flash = less than 5%
HT-680R
500
81 M 5½ H
Lumen
680
89 M 4 H
Lumen
340
27 M 5 H
Lumen
180
18 M 11½ H
Lumen
30
7 M 30 H
Lumen
On/Off Switch
Warm white high
CRI Flood LED