Horizontale Einstellungen; Timebase:position - Rohde & Schwarz R&S Rtb2000 Benutzerhandbuch

®
R&S RTB2000

15.4.5 Horizontale Einstellungen

TIMebase:SCALe
TIMebase:POSition
TIMebase:REFerence
TIMebase:ACQTime
TIMebase:RANGe
TIMebase:DIVisions?
TIMebase:RATime?
TIMebase:SCALe <TimeScale>
Sets the horizontal scale for all channel and math waveforms.
Parameter:
<TimeScale>
Handbedienung:
TIMebase:POSition <Offset>
Defines the trigger position, the time distance from the trigger point to the reference
point (trigger offset). The trigger point is the zero point of the diagram. Changing the
horizontal position, you can move the trigger, even outside the screen.
See also:
Parameter:
<Offset>
Handbedienung:
TIMebase:REFerence <ReferencePoint>
Defines the time reference point in the diagram. The reference point is the rescaling
center of the time scale on the screen. If you modify the time scale, the reference point
remains fixed on the screen, and the scale is stretched or compressed to both sides of
the reference point.
The reference point defines which part of the waveform is shown. By default, the refe-
rence point is displayed in the center of the window, and you can move it to the left or
right.
Benutzerhandbuch 1333.1611.03 ─ 12
...........................................................................................................337
........................................................................................................ 337
.....................................................................................................337
.......................................................................................................338
..........................................................................................................338
......................................................................................................338
........................................................................................................338
Bereich:
Inkrement: 1e-9
*RST:
Std.-einheit: s/div
Siehe „[Scale]"
Siehe „Zeitbasis"
TIMebase:REFerence
Bereich:
Inkrement: 0.01
*RST:
Std.-einheit: s
Siehe „[Position]"
Siehe „Horizontale Position"
1e-9 bis 50; lower limits are possible if zoom or
FFT is enabled.
100e-6
auf Seite 56
auf Seite 58
auf Seite 337
Depends on time base setting
0
auf Seite 56
auf Seite 58
Fernsteuerbefehle
Messkurveneinrichtung
337