Accessories - Black & Decker BHSM15FX08 Originalanweisungen

ENGLISH
Hints for optimum use
General
Caution: Never use the steam mop without first attaching a
cleaning pad.
Always vacuum or sweep the floor before using the steam
u
mop.
The easiest way to use the appliance is to tilt the unit to
u
a 45º angle and clean slowly, covering a small area at a
time.
Use water only with no additives or chemicals with your
u
steam mop. To remove stubborn stains from vinyl or
linoleum floors, you can pre-treat with a mild detergent
and some water before using the steam mop.
Steam Cleaning with the mop
Fit hand steam cleaner to the floor extension (7).
u
Place a cleaning pad (18) on the floor with the velcro 'loop'
u
side facing up.
Lightly press the steam mop down onto the cleaning pad
u
(18).
Connect the steam mop to the mains.
u
Press the ON/OFF button (1). It takes approximately 30
u
seconds for the boiler to heat up..
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Once boiler is up to temperature, Press the required
u
steam setting button to start steam flow
It takes a few seconds for steam to enter the cleaning pad.
u
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
Push and pull the steam mop slowly across the surface to
u
thoroughly steam clean each section.
When you have finished using the steam mop, press the
u
steam flow button to stop steam flow, return to an upright
position, making sure that it is supported and turn "OFF".
Wait until the steam mop cools down (Approx 5 mins).
Caution! It is important to monitor the water level in the water
tank. To refill the water tank and continue to sanitize/clean
stand the mop upright making sure that it is supported and
turn the steam mop 'OFF'.
Unplug the unit from the electrical wall outlet, and refill the
water tank.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
After use
Wait until the steam mop cools down.
u
Unplug the steam mop from the electrical wall outlet.
u
Empty the water tank.
u
12
(Original instructions)
Remove the cleaning pad (18) and wash it ready for next
u
use (take care to follow the wash care instructions printed
on the cleaning pad).
Steam Cleaning with the
head
Fit hand held steamer to the counter top mop (10)
u
Place cleaning pad (18a) onto the counter top with velcro
u
loop side facing up
Lightly press the counter top floorhead onto the cleaning
u
pad (18a)
Connect hand held steam mop to the mains
u
Press the on/Off button (1). It takes approx 30 seconds for
u
the boiler to heat up
Once boiler is up to temperature, Press the required
u
steam setting button to start steam flow
It takes a few seconds for steam to enter the cleaning pad/
u
The steam mop will now glide easily over the surface to be
cleaned
When you have finished using the steam mop, press the
u
steam flow button to stop steam flow, return to an upright
position, making sure that it is supported and turn "OFF".
Wait until the steam mop cools down )Approx 5 mins).

Accessories

The performance of your appliance depends on the accessory
used. BLACK+DECKER accessories are engineered to high
quality standards and designed to enhance the performance
of your appliance. By using these accessories you will get the
very best from your equipment.
Garment steam cleaning (Fig. H)
BHSM15FX10)
Attach the required accessory (15).
u
Attach the required pad (15a).
u
Note! The garment head (15) should not be used without the
pad (15a).
Connect the hand held steam cleaner to the mains.
u
Press the ON/OFF button (1). It takes approximately 30
u
seconds for the boiler to heat up.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Once boiler is up to temperature, Press the required
u
steam setting button to start steam flow.
When you have finished using the steam mop, press the
u
steam flow button to stop steam flow, return to an upright
position, making sure that it is supported and turn "OFF".
Wait until the steam mop cools down (Approx 5 mins).
On pole storage (Fig. I)
The appliance comes with an on pole storage unit (17).
Clamp the on pole storage unit (17) onto the floor
u
extension pole (7).
small worktop mop
(Available with
(Available with BHSM15FX10)