Inhaltsverzeichnis
Werbung
1. Charging
2. Pairing with Bluetooth device
1
AHC-830NCW EM_210819.indd
Charge the earphones using the included charging case and
USB cable before use.
1. Remove the power supply prevention film from the
earphones.
2. Put the earphones in the charging case (included) and
close the lid.
3. Connect the charging case to the AC adapter
(commercially available) with the USB cable (included).
The LED on the charging case will light up according to
the remaining charge of the earphones.
It will take approx. 2 hours from empty to full charge. The
earphones can be used for approximately 4.8 hours (with
noise cancel on) when the battery is fully charged. When the
rechargeable battery is low, a notification sounds.
Pair the earphones with the Bluetooth device you want to
connect.
1. Open the lid of the charging case.
The earphones will automatically turn on, and the pairing mode
will be activated with a notification sound from the earphones.
2. Activate Bluetooth function of the Bluetooth device to
be connected.
3. Select the "DENON AH-C830NCW" appears on the
Bluetooth device to be connected.
A notification sound will be heard from the earphones
when it is connected.
• To pair with other Bluetooth devices or pair with the using device
again, put the earphones in the charging case, and press and hold
button on the rear of the charging case for 2 seconds or more with
the lid open. The LED on the charging case of this unit blinks slowly
in white, and enters pairing mode.
• If you are requested to enter a PIN code (pass key), enter "0000"
(four zeros).
1
2021/08/20
14:59:56
Werbung
Inhaltsverzeichnis
