Charging The Device; Change Batteries - VOSS.SONIC 360 fusion Bedienungsanleitung

9.1

CHARGING THE DEVICE

The VOSS.sonic 360 fusion has a solar panel that supports the
batteries installed in the device during the day when it is regularly
exposed to sunlight for several hours, thereby extending the battery
life. In the absence of sunlight, the batteries in the device must be
recharged regularly using the charging cable supplied.
I nfo
As soon as the control LED inside the front infrared sensor (5)
flashes three times in succession every 10 seconds, the battery
must be charged. This state lasts for 48 hours. If the battery
is not charged within these 48 hours, the device switches off
automatically.
1. To charge the batteries, switch off the device and connect the
supplied USB charging cable to the designated port (9) on the
bottom.
2. Connect the USB port to a USB 2.0 port on your PC or a suitable
USB charging adapter (5V DC, 500 mAh).
WA RN IN G
To prevent possible overcharging of the batteries, use
only the supplied charging cable and a suitable charging
adapter. Disconnect the device from the charging cable
when fully charged.
During the charging process, the control LED inside the front
infrared sensor (5) flashes red. When charging is complete, the
control LED lights up red continuously.
I nfo
The device cannot be used during the charging process using
the USB charging cable.
9.2

CHANGE BATTERIES

The VOSS.sonic 360 fusion is operated with AA 1.2 V, 400 mAh NiMH
rechargeable battery (3 pcs.)
In fo
You can also use rechargeable batteries with a larger battery
capacity. The requirement is that the batteries used are NiMH
batteries.
26
INSTRUCTION MANUAL VOSS.SONIC 360 FUSION
45085 - 01.2022 - V1