Lacor 69341 Gebrauchs- Und Instandhaltungsanleitung Seite 33

1
COARSE
Sharpening Flat Screwdrivers
a) Use the screwdriver groove (3) for sharpening flat head screwdrivers. Gently push
down on it to remove deformations in the tip of the screwdriver (PHOTO 1).
b) Use the fine sharpening grooves (2) for sharpening the sides of a flat screwdriver.
To sharpen, put the screwdriver into the right and left groove vertically and push
down gently. Repeat that process about 3 to 4 times until you get the desired angle
(PHOTO 2).
Sharpening scissors
a) Use the scissor sharpening groove (4) on the right side of the machine.
b) Put the scissors in as shown in PHOTO 1 and slide them to the tip. Repeat the
process 3 to 4 times for each side. Rotate the scissors 180º for that purpose.
4.- Turn off the ON/OFF switch (5) and unplug the unit.
2
COARSE
1
1
3
FINE
2
4
FINE
33