Machine Information - Ferm LBM1012 Originalbetriebsanleitung

- before checking, cleaning or maintaining
the appliance;
- if the appliance starts to vibrate abnormally;
- whenever you leave the machine.
• Always be sure of your footing on slopes.
• Walk, never run.
• Keep all cooling air inlets clear of debris or
obstructions.
• Keep all nuts, bolts and screws tight to be sure
the appliance is in safe working condition.
• Check the debris collector frequently for wear
or deterioration.
• Replace worn or damaged parts.
• Use only genuine replacement parts and
accessories.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes and
clutter in the collector.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.

2. MACHINE INFORMATION

Intended use
The leaf blowers are developed to remove leaves
from the street, garden and lawn. A fan inside
the leaf blower causes a flow of air, which can be
used to blow leaves away.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
No load speed
Max. Air velocity
Max air volume
Recommended battery
Weight
Sound pressure level LPA
Sound power level LWA
Vibration value
Only use the following batteries of the FX-POWER
20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CDA1167
CDA1168
The following charger of the can be used to
charge these batteries.
CDA1169
CDA1170
The batteries of the FX-POWER 20V battery
platform are interchangeable with all the FERM
FX-POWER battery platform tools.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in EN
50636-2-100; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
• The times when the tool is switched off or
Protect yourself against the effects of vibration by
LBM1012
maintaining the tool and its accessories, keeping
20V
your hands warm, and organizing your work
13000/min.
patterns.
180 km/h
5 m³/min
DESCRIPTION
CDA1168 20V ~ 4AH
The numbers in the text refer to the diagrams on
1.22 kg
page 2-3.
76.3 dB(A) K=3 dB(A)
84.7 dB(A) K=3 dB(A)
1. On/Off button
1.370 m/s K=1.5 m/s
2 2
2. Battery
3. Battery unlock button
4. Upper tube
5. Lower tube
20V, 2Ah Lithium-Ion
20V, 4Ah Lithium-Ion (recommended)
Charger adapter
Quick charger
different or poorly maintained accessories,
may significantly increase the exposure level.
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
7