Before First Use - Overmax X-bee drone 9.5 Bedienungsanleitung

Photo / video
Press the camera key briefly to take a photo. The camera icon
EN
for a while on the displa.
Hold the camera key for at least 2 seconds and the drone camera will start
recording a video. A flashing icona
camera key longer to finish recording (see: fig. 27).
NOTE: when there is no memory card in the camera or the memory card is
damaged, you cannot take pictures or record videos through a remote control
key. In such situation this option is available through a smartphone app only.
The memory card slot is on the rear of the camera. Maximum capacity of
the MicroSD card: 32 GB.

Before first use

1.
2.
3.
How to start fast
1.
2.
3.
4.
5.
6.
How to pair the drone with the app
Switch the drone on. Enter WiFi settings on your mobile phone. Find and
select the network called „drone4******". Enter the application - M RC
PRO, and then press „Start" to see the real-time broadcast from the drone.
Check if the battery of the remote control and drone is full.
Check if the airscrews have been installed properly.
Check if motors work properly after the drone has been unlocked.
Pair the remote control with drone. Perform detection procedure.
Calibrate the drone compass.
Unlock the drone.
Push the bar to lift the drone (A in fig. 22). Now you can control the
route of the flight.
Land the drone. Lock the drone.
Remove the battery from the drone and switch the controller off.
. Pshows up on the display. Hold the
will glow