Waste Disposal - Extol Craft 252 Bersetzung Der Ursprünglichen Bedienungsanleitung

5) SERVICE
Have your power tool repaired by a qualified person
that will use identical spare parts. This will ensure that
the same level of safety will be achieved as before the repair
of the power tool.
IV. Features
The Mini Compressor Extol Craft is intended for inflating
tyres on cars, bicycles, inflatable toys, mattresses, etc. The
power supply is provided by means of a 12 V car cigarette
lighter socket. The compressor has a built in pressure
gauge.
V. Reference
to pictograms and labels
Meets EU requirements
Before starting it for the first time,
carefully read the user's manual.
Protective glasses are unconditiona-
lly necessary during operation.
EN
VI. Use and safety
instructions
1) Start the car and insert power adapter of the compre-
ssor into a 12 V car cigarette lighter socket.
2) Seat the end on to a valve and lock it in place using
the lever.
3) While inflating, take care that the maximum pressure
does not destroy the inflated item.
4) If the compressor begins to overheat, disconnect it
and continue after a short while.
•
ATTENTION
For safety reasons, tyres must be inflated to their prescri-
bed pressure.
VII. Waste disposal
It is necessary to dispose of the product
at the end of its service life in accordance
with the applicable legislation. The
product contains electric/electronic
components. Do not throw this product
in with communal waste, take it to
a processor of waste materials or to a recycling centre or
to a collection location for this type of waste. Operating
liquids are dangerous waste. Handle them in accordance
with valid legislation and according to their manufactu-
rer's instructions.
20
ES Declaration of Conformity
Subject of declaration - model, product identification:
Extol Craft 252
Air compressor 12 V
Manufacturer Madal Bal a.s. Bartošova 40/3, CZ-760 01 Zlín • Company ID No.: 49433717
hereby declares
that the product described above
is in conformity with all relevant stipulations of harmonisation legal regulations of the European Union:
2006/42 ES; (EU) 2011/65; (EU) 2014/30;
This declaration is issued under the exclusive responsibility of the manufacturer.
Harmonisation norms (including their amendments, if any exist), which were used
in the assessment of conformity and on the basis of which the Declaration of conformity is issued:
EN 60335-1:2012; EN 1012-1:2010; EN 62233:2008; EN ISO 12100:2010; EN 55014-1:2017; EN 55014-2:2015; EN IEC 63000:2018;
The technical documentation (2006/42 ES) was drawn up by Martin Šenkýř
at the business address of Madal Bal a.s., Průmyslová zóna Příluky 244, 760 01 Zlín, Czech Republic.
The technical documentation (2006/42 ES) is available at the aforementioned business address of Madal Bal, a.s.
Place and date of issue of ES Declaration of Conformity: Zlín 11.05.2020
On behalf of
Madal Bal, a.s.:
Martin Šenkýř
Member of the Company's Board of Directors
21
EN