Preparing To Cook; How To Use The Custom Setting; How To Use Presets - pampered chef Deluxe 100461 Anleitung

PREPARING TO COOK

1. Plug the cord into a 220-240V, 50Hz power source. Be sure the outlet is designated for the air fryer and has nothing
else plugged into it.
2. Open the air fryer door and place the drip tray on the bottom of the cooking chamber. Be sure the center of the drip
tray is raised.
3. Place the food in the desired air fryer accessory.
4. Place the accessory in the air fryer.
5. Turn the wheel to the desired setting and press the wheel to start.

HOW TO USE THE CUSTOM SETTING

1. The air fryer will default to the standby mode. You will see the display light up with 6 blinking center lines. Ensure
the product is plugged into its own dedicated outlet.
2. Place the accessory into the chamber and close the door.
3. Press the Custom button.
4. The time will blink 0:15 minutes and 350°F (180°C) will be solidly displayed. Turn the wheel to adjust the time in
1-minute intervals. Once the desired time is displayed, press the wheel to select. You will hear 1 beep.
5. The temperature (350°F/180°C) will now blink. Turn the wheel to adjust the temperature in 5°F (5°C) intervals. Once
the desired temperature is displayed, press the wheel to select. You will hear 3 long beeps.
6. Halfway through cooking, there will be a series of beeps. This indicates that the cooking trays should be switched
for even cooking.
7. The time will start to countdown. Once the time runs out, "End" will display and you will hear 3 beeps.
8. Press Cancel or open the door to return to standby mode.

HOW TO USE PRESETS

1. The air fryer will default to standby mode. When plugged into a 220-240V, 50Hz power source, you will see the display
light up with 6 blinking center lines. Ensure the product is plugged into its own dedicated outlet.
2. Place the desired accessory into the chamber and close the door.
3. Turn the wheel to select a setting (see the chart below). Once the blue light is next to the desired setting, press the wheel
and you'll hear 1 beep. When using a preset (except Dehydrate, see instructions below), you can adjust the time but not
the temperature. If you would like to adjust the temperature, use the Custom setting.
See How to Use the Custom Setting.
4. On the display, the time will blink and the temperature will remain solidly lit. Adjust the time by turning the wheel if needed.
Once the time needed is displayed, press the wheel. You will hear 3 long beeps and the countdown will begin.
• For Dehydrate: After you select the time, you will see the time remain solidly lit and the temperature blink. Turn the wheel
to the desired temperature and press to select. You will then hear 3 long beeps and the countdown will begin.
5. Halfway through cooking, there will be a series of beeps. This indicates that the cooking trays should be switched for even
cooking. After switching the trays, once you close the door, the cooking cycle will continue.
2. Position the retrieval tool lift hooks beneath the left and right arms of the rotisserie.
3. With the lift hooks in place, push the rotisserie to the right with the retrieval tool to release.
4. Carefully lift up and out to remove from the cooking chamber.
13