Initial Test Run; How To Insert And Remove Accessories - pampered chef Deluxe 100461 Anleitung

2. The unit defaults to Fahrenheit. To switch to Celsius, turn the wheel to Air Fry. Press and hold the Light and
Cancel buttons at the same time for 3 seconds. Repeat to switch back to Fahrenheit.
3. Open the air fryer door and place the drip tray on the bottom of the cooking chamber. Close the door. For this test
run, do not add food to the chamber.
WARNING: The air fryer will be hot during and after cooking. Do not touch hot surfaces.
Always use oven mitts to remove all contents (accessories and food). Allow the air fryer to
cool completely before cleaning the accessories and cooking chamber. See the Cleaning
section for further instructions.

HOW TO INSERT AND REMOVE ACCESSORIES

WARNING: The rotisserie set, trays, and basket will be hot during and after cooking.
Always use the retrieval tool to remove the rotisserie set and basket. Allow to cool slightly
and exercise extreme caution when removing hot accessories from the cooking chamber.
Always use oven mitts when disassembling or retrieving hot accessories.
CAUTION:Ensure food is able to rotate freely. Do not allow foods to touch the
heating coil.
Trays
WARNING:Always place the trays into the cooking chamber before beginning a
cooking cycle.
• Drip tray: Place the drip tray in the bottom of air fryer cooking chamber prior to each use. Use caution when handling
if it's hot.
• Cooking trays (2): Align the cooking trays with the slots on the inside of the air fryer. Push the cooking trays back
until they are fully seated in the air fryer.
• Removable shield: Align the removable shield with the top of the slots on the inside of the air
Basket
WARNING:Always fill the basket before placing into the cooking chamber and
before beginning a cooking cycle in the air fryer. Always use the retrieval tool and
oven mitts when removing the basket.
10

INITIAL TEST RUN

1. Plug the cord into a 220-240V, 50Hz power source. Be sure the outlet is
designated for just the air fryer and has nothing else plugged into it. Six
blinking centerlines indicate the air fryer is on and in standby mode.
4. Turn the wheel until the Reheat indicator is lit. Press the wheel and you
will hear 1 beep. The time will blink and the temperature will be solidly
lit. Turn the wheel counterclockwise to set the time for 3 minutes. Press
the wheel. You will hear three beeps, the time will be solidly displayed,
and the countdown begins. Halfway through the cycle, you'll hear a
series of beeps reminding you to switch the cooking trays when cooking.
5. When time ends, you will hear 3 beeps and "End" will be displayed.
The heat will turn off and the fan will remain on for 30 seconds to
help cool the unit down.
fryer. The removable shield is intended to separate the cooking chamber from the heating coil.
The removable shield is NOT intended to be used as a cooking tray.