Filter Replacement - Jya Fjord Pro Bedienungsanleitung

Filter replacement

Warning: Make sure to turn off the air purifier and disconnect power before replacing the filter.
01 Opening the filter compartment 02 Removing the old filter
Press and hold the release Pull the strap and remove the filter.
buttons to open the filter
compartment cover.
Notes:
Replace the filter in time according to the filter life notification.
Please purchase genuine and compatible filters from official channels
09
03 Installing the new filter
Remove the packaging bag.
Place the new filter, and close
the filter compartment cover.
Linking the Device to
Intelligent Control with Apple HomeKit
Smartmi Link
1
This product has been linked to the Open the Home app on your iPhone/iPad.
Smartmi Link and can be controlled
2
Tap "Add Accessory" and then scan the HomeKit setup code on the
using the app.
product sticker (two stickers on the device unit, see illustration), or enter the
Scan the QR code or search for eight-digit setup code above the HomeKit Setup Code. The device will then
"Smartmi Link" on the app store to be linked to the Apple Home app.
download and install the app. Go
to the app's homepage, click "+" in The device can be linked to
the middle of the page, then add the Smartmi Link after linking to
device as prompted.
HomeKit. Go to the Personal
Info page on Smartmi Link.
Tap "HomeKit Info" and then
link the HomeKit device as
prompted.
Devices linked to Smartmi Link
can also be added to HomeKit.
Go to the Device Control page
on Smartmi Link. Tap "Add
to HomeKit" in "Settings" and
then link the device to HomeKit
as prompted.
Note:
Please ensure that your Wi-Fi network is both
available and has Internet access. Place your
phone as close to this product as possible. (This
product does not support 5G networks)
This product will be listed as "Jya Fjord Pro Air
Purifier " in the app's device listing.
* If you need more detailed instruction, please visit:
https://www.smartmiglobal.com/pages/helpcenter
10
Note:
Please ensure that your Wi-Fi network is both
available and has Internet access. Place your
phone as close to this product as possible.
(This product does not support 5G networks).
To control this accessory which is compatible
with HomeKit, it is recommended to use iOS
13.0 or a later version.
Please keep the HomeKit setup code, as you
will need to scan the code to link the device to
HomeKit after a factory reset.
iPad and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
Controlling this HomeKit-enabled accessory
automatically and away from home requires a
HomePod, Apple TV, or iPad set up as a home
hub. It is recommended that you update to the
latest software and operating system.
HomeKit Setup Code