Preliminary Operations; Power Supply - REKKORD AUDIO F 110 Bedienungsanleitung

1 Dustcover
2 Hinge
3 Cue control
4 Speed selector
5 Start-Stop-Switch
6 Transportation lock
7 Tonarm rest
8 Phonocable
9 Ground
10 Socket for power supply
11 Stylus

Preliminary operations

Unpack the unit and all accessories. Please keep the packaging for future use
when transporting the device.
Remove the two transport lockings 6 by pressing them sidewards (fig. 1).
Fit the platter and depress the locking mechanism in its centre until it engages in
the groove of the platter spindle (fig. 2).
Insert the hinges 2 in the appropriate recesses (fig. 3).
Slide the cover 1 parallel to the position of the hinges 2 (opening angle
approximately 60°) until it locks in position. In this position, the cover can be
removed at any time.

Power supply

The delivered power supply will be connected to the socket 10 at the back of the
device. The mains set, corresponding to the voltage indication on the nameplate has
to be plugged in to a power-supply plug either with 230V/50 Hz or 115 V/60 Hz on the
primary side.
Fig. 1
ENGLISH
Connection to amplifier or preamp (F110)
Connect the phonocables 8 to the phono-magnetic-inputs of the amplifier or
preamp (red or black RCA-type plug = right channel, white RCA-type plug = left
channel).
Connect Ground 9 to the ground connector of your amplifier or preamp.
Connection to amplifier (F110 P)
Connect the phonocables 8 to a Line Input (CD/AUX) of your amplifier (red or black
RCA-type plug = right channel, white RCA-type plug = left
channel).
The Ground 9 has no function in this case.
Fig. 2 Fig. 3