Do not paint the device.
Do not manipulate any element as this may lead to product failure, short circuit and risk of
death.
Get fresh air outside immediately or open all doors / windows to ventilate the room and
allow the CO to dissipate.
If possible, turn off the fuel burning appliance.
Evacuate people from the building.
Do not re-enter the property or approach open doors / windows until emergency services
arrive, the property is aired, and your sensor returns to normal operation.
Seek medical attention immediately for anyone suffering from symptoms of headache,
drowsiness, nausea, etc.
Do not use the equipment again until it has been checked by a qualified technician and the
fault has been located and rectified.
Device response time (in accordance with EN50291)
CO concentration
50 ppm
100 ppm
300 ppm
WARNING: Avoid using the CO Alarm in the following situations to not affect
the alarm lifetime: The device should avoid contact with organic solvents
(including silicone and other adhesives), coatings, drugs, oils and high
concentration gases. This device must not be used in an environment
containing a corrosive gas that may damage the device.
Time until alarm sounds
60 – 90 minutes
10 -40 minutes minut
3 minutes