Story MONARCH 10'4 Bedienungsanleitung Seite 13

EN
- Do not exceed the maximum weight capacity.
- Do not operate the SUP board under the in uence of drugs and/or alcohol.
- This model is designed to be used in at waters (lake, rivers, sea shore) in standing and
seating position. It is not recommended to use the SUP board in high waves nor for
sur ng.
- Beware of o shore winds and currents as they can take you out to sea.
- Check your equipment prior to each use for signs of wear, leaks or failure.
- Tie the included leash to your SUP board at all times.
- Children should always be under adult supervision.
- Always inform someone your paddling route, the time and place of departure and your
intended time and place of arrival. Paddling alone is not recommended.
- Watch out for other beach users especially swimmers and children. Make sure you keep
the SUP board and paddle under control at all times.
INTRODUCTION FOR ASSEMBLING AND DISASSEMBLING THE SUP
PREPARATIONS FOR INFLATING THE SUP BOARD
Remove all sharp edged and pointed objects from the surface in order to avoid damaging
the SUP board.
ASSEMBLY INSTRUCTIONS / INFLATION / DEFLATION
In ate the SUP board with the included hand pump.
INSTRUCTION
1. Valve cap
2. Button
3. Valve base
Unscrew the valve cap (1). Push the button (2) in and
turn approximately 90 degrees so it is in the "OUT"
position.
Insert the pump hose end piece and in ate it until you
will reach the required pressure. After in ation tighten
all the valve cap (clockwise). Only the valve cap can
ensure nal AIR TIGHTNESS.
To release air from the SUP board, remove the valve cap
(1) and push the button
13.