SUPERPOOL SMG500 Produkthandbuch Seite 3

MAIN DIMENSION
START UP
1. Be sure correct amount of filter media sand is in tank and that all connections have been made
and are secure.
2. Depress control valve handle and rotate to BACKWASH position. (To prevent damage to control
valve seal, always depress handle before turning.)
3. Prime and start pump according to pump instructions (bе sure all suction and return lines are
open). allowing the filter tank to fill with water. Once water is flowing out of the waste line. run the
pump for at least 1 minute. The initial back washing of the filter is recommended to remove any
impurities or fine sand particles in the sand media.
4. Turn pump off and set valve to RINSE position. Start pump and operate until water in sight glass is
clear. about 1 /2 to 1 minute. Turn pump off and set valve to FILTER position and restart pump. The
filter is now operating in the normal filter mod e, filtering dirt particles from the pool water.
5. Adjust pool suction and return valves to achieve desired flow. Check system and filter for water
leaks and tighten connections, bolts. nuts as required.
6. Note the initial pressure gauge reading when the filter is clean. (lt will vary from pool to pool
depending upon the pump and general piping system.) As the filter removes dirt and impurities from
the pool water. the accumulation in the filter will cause the pressure to rise and flow to diminish.
When the pressure gauge reading is 1.5 bar, higher than the initial "clean" pressure you noted, it is
time to backwash the filter (see BACKWASH under filter and control valve functions).
NOTE: DURING INITIAL CLEAN-UP OF THE POOL WATER IT MAY BЕ NECESSARY TO BACKWASH
FREQUENTLY DUE TO THE UNUSUALLY HEAVY INITIAL DIRT LOAD IN THE WATER.
FUNCTIONS OF VALVE
POSITION
FILTER
BACKWASH
RINSE
WASTE
RECIRCULATE
CLOSED
Model
SMG500
SMG650
SMG750
SMG900
FUNCTION
Normal Filtration
Cleaning Filter bу reversing the flow
Used after backwash to flush dirt from valve
By-passes filter, used for vacuuming to waste or lowering water level
By-passes filter for circulating water to pool
Shuts off all flow to filter or pool
Height Diameter
A (mm) B (mm)
850 516
943 666
1020 770
1130 920
Valve Sand
(inch) (kg)
1.5'' 100
1.5'' 150
2.0'' 250
2.0'' 375