SUPERPOOL SMG500 Produkthandbuch Seite 2

WARNING

THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM
!
(E.G., CLAMP, PUMP, FILTER, VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND
BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID OR VALVE TO BE BLOWN OFF
WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE. DO NOT UNSCREW
SCREWS OF FLANGE CLAMP WHILE FILTER OPERATING.

!
TURN PUMP OFF BEFORE CHANGING VALVE POSITION.

TО PREVENT DAMAGE TО THE PUMP AND FOR PROPER OPERATION OF THE SYSTEM, CLEAN
!
PUMP STRAINER AND SKIMMER BASKETS REGULARLY.

!
UNDER LOW TEMPERATURE SHUT OFF CONDITION, IT IS STRONGLY RECOMMENDED TO TURN TO
WINTERISE POSITION AND DISCHARGE ALL THE WATER INSIDE FILTER THROUGH THE BOTTOM
DRAIN.
FUNCTION
The filter uses special filter sand to remove dirt particles from pool water. The filter sand is loaded into
the filter tank and functions as а permanent dirt removing media. When the control valve is in the
FILTER position, the pool water which contains suspended dirt particles, is pumped through your
piping system and is automatically directed by the patented filter control valve to the top of the
filter tank. As the pool water is pumped through the filter, dirt particles are trapped by the sand bed,
and filtered out. The cleaned Pool water is returned from the bottom of the filter tank, through the
control valve and back to the pool through the piping system. This entire sequence is continuous
and automatic. lt provides for total recirculation of pool water through your filter and piping system.
After а period of time, the accumulated dirt in the filter causes а resistance to flow, and the flow
diminishes. This means it is the time to clean your filter. With the control valve in the BACKWASH
position, the water flow is automatically reversed through the filter so that it is directed to the bottom
of the tank, up through the sand, flushing the previously trapped dirt and debris out the waste line.
Once the filter is backwashed of dirt, set control valve to RINSE position and run pump for about 1 /2
to 1 minute, and then set the control valve in the FILTER position, to resume normal filtering.
NOTE: TURN PUMP OFF BEFORE CHANGING VALVE POSITION.
INSTALLATION
Pipe sealant for plastic adapters are required to install and service the filter.
1) The filter should be placed on a level concrete slab, very firm ground, or equivalent. Position the
filter so that the piping connections, control valve are convenient and accessible for operation and
service.
2) Loading the sand media. Filter sand media is loaded through the top opening of the filter.
a) Place two O-rings on the side of the filter tank and Connect control valve to the filter using
pipes with unions and glues.
b) Loosen the Ring lock Nut by 2 handles and remove the lid.
c) We recommend filling tank approximately 1/3 way with water to provide a cushion effect
when the filter sand is poured in. This helps protect the under-drain laterals from excessive shock.
d) Carefully pour in correct amount and grade of filter sand. Sand surface should be leveled and
should come to about the middle of the filter tank.
3) Install the valve. Tighten the Ring Lock Nut by 2 handles and make sure the nut is "sand free" on
its thread.
a) Carefully screw the T-shape Exhaust Switch onto the filter lid and make sure there do not
over-tighten.
b) Ensure T-Shape Exhaust switch is tight fit to filter lid and turn it easily.
4) Connect pump to control valve opening marked PUMP.
5) Make return to pool pipe connection to control valve opening marked RETURN and complete
other necessary plumbing connections, suction lines to pump, waste, etc.
6) Make electrical connections to pump per pump instructions.
7) To prevent water leakage, be sure all pipe connections are right.