MoMi GLOSSY Bedienungsanleitung Seite 11

USE:
1. Check the all parts with above list before assembly.
2. Place the left and right support frames opposite each other, with the rear connector tube between
them on a fl at surface(1).
3. Lift the fl ip clip on the both side of the rear connector tube, fi t the left support frame & right support
frame into the rear frame tube. Close the fl ip clip over the tube and push down until the fl ip clip locks
in place(2,3).
4. Fit both ends of the footrest frame together and screw down(4,5).
5. Fit both ends of the backrest frame together by holding down the spring loaded pin and push the
frames till the pin locates into the holes(6).
6. Open the pocket at the rear of the seat cover back and slide over the seat backrest, stretch the bot-
tom of the seat cover over the footrest frame(7) .
EN 11