Packwise Smart Cap Montageanleitung Seite 7

Step 1: Choose the right location
1) Choose a suitable location on the top of your
container to attach Packwise Smart Cap.
2) Clean the chosen suitable place (the surface
should be dry, free of dirt, dust, oil and grease).
Conditions for a suitable location are:
It is clean and dry.
The temperature during installation is between
18 and 35 degrees Celsius.
It is in the middle, between the edge and the lid,
of the container (see coloured area).
12
suitable location
Step 2: Activate sensor
1) Remove the rubber stopper from the bottom side
of the device and take out the magnet inside to
activate the sensor.
2) Place back the rubber stopper. Put the magnet
aside.
IMPORTANT: The magnet must remain permanently
removed, otherwise the device will be deactivated again.
NOTE: The Packwise Smart Cap should be attached to
the container (Step 3) within 2 minutes of its activation
(Step 2).
13