NOVARDEN NRL630 Benutzerhandbuch Seite 19

Troubleshooting
The robot mower
cannot detect its
charging station.
The robot mower
does not reach the
charging pins
The robot mower
behaves abnormally
around flower beds
The robot mower
goes outside the
perimeter cable.
1. The charging station
is not on a flat
surface.
2. The charging station
is not powered
correctly.
1. There is a difference
in level between the
entrance and back of
the charging station.
2. The perimeter cable
is not correctly
installed under the
charging station.
The perimeter cable is not
installed correctly
The wire is not connected
correctly or has been cut.
17
1. Reboot the charging
station on a flat surface.
2. Check the charging
station is plugged in.
1. Make sure the charging
station is not too
high off the ground.
If necessary, level the
ground with soil.
2. Check and readjust
the perimeter cable
installation under the
charging station.
Check the perimeter cable
is installed correctly and the
"Out" wire does not cross
the "In" wire.
Check the perimeter cable's
condition and that it is
connected correctly.
EN