Operational Elements; Safety Procedures; Fastening Of The Electrode In The Electrode Holder - ULTIMA TIG UT 03 Bedienungsanleitung

INELCO A/S
The ULTIMA-TIG must not operate without grinding liquid!!
The ULTIMA-TIG does not contain grinding liquid on delivery. Before starting the
machine grinding liquid must be applied. Take out the drain plug (8) and fit the enclosed
liquid container (39) to the machine. Place the filler neck on to the enclosed container.
Feed the ULTIMA-TIG with the grinding liquid through the hose (29) until the correct liquid
level has been reached (please see mark on the inspection cover frame (7)). There is
sufficient liquid in the grinding chamber when the diamond wheel is seen to pump the
fluid as the machine is switched on.
For safety reasons the grinding liquid must be drained from the ULTIMA-TIG into a
sealed closed container during transport.
ULTIMA-TIG can be operated in locations with surrounding temperatures ranging from
-10C to +40C and a relative humidity up to 50% at 40C and 90% at 20C.
The machine has been tested in accordance to protection class IP21.
4.

Operational elements


Current and main switch

Carry handles

Degree scale

Electrode holder

Stick-out adjustment

Grinding fluid container 250 ml

Micrometer screw to flatten the tip of the electrode
5.

Safety procedures


Never use the product if the grinding wheel is damaged

Use only grinding wheels recommended by Inelco A/S

Only use the product when all parts have been assembled
6.

Fastening of the electrode in the electrode holder

Place the electrode clamp fitting the diameter of the tungstenelectrode into the electrode
holder. Push the electrode through the electrode clamp and into the electrode holder. Use
your fingers to tighten the electrode lightly, please ensure that it may still be able to slide
in the electrode holder. The electrode must be extended approx. 2 cm from the clamp.
Then place the electrode and the holder into the stick-out setting(10) placed below on the
right front side until it stops and tighten the electrode with a smooth turn of the electrode
holder to the right. The electrode clamp has a hexagon which fits the hole of the stick-out
setting. The electrode may only be fastened so tight, that it does not slide in the electrode
clamp. If the electrode is fastened too tightly the clamp may be damaged. A regulation
Inelco A/S, Haandvaerkervej 6, DK-9690 Fjerritslev, Denmark
E-mail: inelco@inelco.com
ULTIMA-TIG
33/40