Getting Started; System Settings - Usogood TC20 Bedienungsanleitung

Getting Started

EN EN
Insert the (Micro SD card) with the notched corner in the direction
asillustrated

System Settings

Please make sure to place the batteries inside of the camera before
using.
1.1 First open the camera by swiveling the base plate. Find the battery
compartment cover to open it. Insert 4 or 8 X1.5V AA batteries into the
battery slot.
1.2 If you put inside 4pcs X1.5V batteries, make sure to place them all
in first half of the battery compartment or the second half battery
compartment. 4pcs batteries are not allowed to be put in both first half
and second battery compartments.
1.3 If you want to use the power adapter (not included) as a power
supply, open the round rubber seal on the base camera and connect the
plug of the adapter cable into the socket.
1.4 Inserting memory card.
Memory card toward the front insert
Note: The camera doesn't have built-in hard disk memory. A memory
card must be inserted into the camera before using. After inserting the
memory card, make sure to format the memory card in the camera first.
System Settings
1. Power on and off / System settings
After inserting the batteries into the camera, put the operating mode
selector switch to "SETUP" position to make the settings described on
the following pages. In SETUP mode, the infrared lamp is closed.
1.1 To put the operating mode selector switch from "OFF" to "SETUP",
the camera is on.the camera is on.
1.2 Press the Up/Down key to switch modes between photo and video
mode.
1.3 Press the MENU key to open settings menu. Press OK to confirm the
setting changes.
1.4 Press the MENU key one more time to return to previous menu or
exit the settings MENU.
1.5 switch the mode selector to "OFF" to power off the camera.
3