Assembly; Handle Bar Assembly; Drive Unit Assembly; Mud Guard Assembly - Zipper Maschinen ZI-MOS145G Bedienungsanleitung

3.2 Assembly

3.2.1 Handle bar assembly

Loosen the premounted screws of the
handle bar bracket and insert the han-
dles A and B from the side into the
bracket.
Tighten the handles to the bracket by
tightening the screws.

3.2.2 Drive unit assembly

Mount the drive unit C to the pole with
the 4pcs M5x30 Screws.
Take care that the pole is inserted ver-
tically into the green bracket!
Take care that the drive unit is mount-
ed correctly to the pole.
The tank cap must be positioned as
shown in D.

3.2.3 Mud guard assembly

Use the remaining screws, washers and nuts to assemble the mud guard to the pole
shaft. Depending on the operation mode you can choose the positioning of the mud
guard! For trimming place the mud guard closer to the pole end choosing holes T. For
mowing/cutting use position T
ZIPPER Maschinen Austria
Motorsense ZI-MOS145G
Mount the drive unit with second person!
A non exact assembly between drive unit and pole will cause ma-
chine damage.
Clean all parts coated with anti corrosion layer with a mild solvent
and then apply a thin layer of oil.
T
S
www.zipper-maschinen.at
A T T E N T I O N
A
A
B
C
D
SETUP
A
21
Seite 21