Service Instructions - MAXOfit MF-27 Bedienungsanleitung

7. Service instructions

Attention: Always disconnect the device from the power supply before servicing or
cleaning it!
1. Treadmill alignment and tension
Do not tighten the treadmill too much! Reduced engine function and heavy wear
of the rollers can be the result.
Alignment of the treadmill:
● Place the device on a level surface.
● Let the treadmill run at about 6km/h.
● If the treadmill is displaced tot he right or left side, tighten the adjustment screw
clockwise until the strap is straightened.
Picture A: Moved to the right Picture B: Moved to the left
Tensioning the belt
If you feel that the running belt is slipping while you are running, it must be
retightened.
In most cases, the tape has stretched after a long use and therefore sits looser. To
remove this phenomenom, retighten both rollers with the adjustment screws. Turn
the respective screw only up to a quarter turn!
6