Maintenance, Cleaning & Defrosting - T.I.P. CROSSXTOOLS ICEBOX 40 Original-Gebrauchsanweisung

Loosen chain
Loosen hinges
Fit hinges here
Fit the chain here
6. Maintenance, cleaning & defrosting
ATTENTION: Before performing any maintenance tasks, disconnect the electrical device from the
power source by pulling the plug out of the socket outlet.
Do not use aggressive solvents or cleaning agents such as scouring agents, bleach, soap powder,
alkaline cleaning agents, petrol, acid, etc. to clean the lid seals and plastic parts.
•
Disconnect the device from the power source.
•
Open the lid and remove all the refrigerated goods from the cooler.
•
Remove coarse dirt and any condensation from the interior.
•
Clean the inside and outside surfaces of the cooler with a soft cloth moistened with warm water.
•
If heavily soiled, use a neutral cleaning agent to clean the cooler. Then rub the surfaces dry with a
soft, clean cloth.
•
The cleaning intervals depend on the degree of soiling of the cooler box.
•
If you are going to be absent for a longer period of time, remove all food from the cooler and unplug it
from the mains. Clean it in accordance with the instructions above and store the cooler with the lid
slightly open to prevent mould. Then place the cooler in a ventilated place. The same applies if you
do not use the cooler for a longer period of time.
•
Store the device in a dry, frost-proof place.
Note: All types of repairs must be carried out by qualified personnel.
The unit contains HFC 1234yf (2,3,3,3-tetrafluoropropene, trade name: R-1234yf) as refrigerant with a very
low GWP value (global warming potential) of 4 (based on 100 years, CO2 = 1). 1234yf is a combustible, col-
orless gas with a faint inherent odor.
Keep ignition sources away from the unit. The gas is under high pressure in the refrigerant circuit. There is a
risk of fire and explosion if it escapes uncontrolled. Immediately take the unit out of operation and contact an
authorized specialist if you suspect that refrigerant has escaped.
All persons who work on the refrigerant circuit must be appropriately trained and have certificates from an
accredited certification body.
6.1 Defrosting the cooling unit
In the following cases, the cool box must be defrosted urgently:
•
Ice can form inside the cool box during prolonged operation. This reduces the cooling performance and
thus also increases the power consumption. In addition, ice formation can also affect the proper closing
of the lid.
5
13