Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
PAIR INSTRUCTION
The first step is to connect the board and the remote control.
Before you start, make sure that the board and the remote control are switched off.
Switch on the board.
Press the power button for 5 seconds until the light of
the power button starts flashing.
Turn on the remote control, and then press the pairing
button. The signal indicator flashes and the power
button light flashes at the same frequency. This then
means that the pairing was successful.
Push the joystick forward to test the acceleration and backward to test the brake.
After the test they have been tested, they are OK, the board can now be used normally.
16
MODSTER SC R1
www.modster.at
Werbung
Inhaltsverzeichnis
