InBody 270 Bedienungsanleitung Seite 8

3. Level the InBody270 by rotating the leveling screws under the footplate to the left and right so that the
air bubble is centered.
* Leveling the equipment is necessary for accurate measurement of weight. There are a total of 4 leveling screws.
Leveling screws under the footplate
UTION NOTE DANGER
참 고 주 의
Avoid injuring your hands when rotating the leveling screws under the footplate.
•
4. Connect the adapter (
to the power cord (
* The InBody270 can be used in connection with other equipment such as a stadiometer, a blood pressure monitor, data management
software called LookinBody, or a barcode reader. For more information, please refer to 'I. InBody270 Installation E.Connecting Printer,
Thermal Printer, Stadiometer, Blood Pressure Monitor, Barcode Reader and SD400' in User's Manual.
UTION NOTE DANGER
참 고 주 의
• Do not place the InBody270 in a location making it difficult to disconnect the power cord.
• Do not plug in or pull out the power cord with wet hands. There is a risk of an electric shock.
• Always use an outlet connected to the power (AC 100 - 240 V). Using other power rated outlets may result in
fire or malfunction.
When using a power surge protector, make sure that the outlet or the extension cable has adequate power capacity.
•
• Do not disassemble or modify the equipment including internal parts without written consent from the
manufacturer. This may cause electric shock or injury, product malfunction, inaccurate results, and will
void the manufacturer's warranty.
8
Caution
참 조 주 의
) to the power input port, which is located on the rear panel (
❷
). Plug the power cord (
❸
❶
Rear panel
Warning
참 조 주 의
) into a grounded 3-socket outlet.
❸
InBody
❷
❸
Level Indicator
Leveled
Not leveled
). Connect the adapter (
❶
Power input port
Grounded outlet
3-socket outlet
)
❷