Seite 1
Aufbauanleitung / assembly instructions mod. 1630 - 1633 Metallfuß, Frontauszug 30 x 10,5 M8 x 65 M10 x 30 4,5 x 45 M5 x 20 B = 179 1. Montagematerial. 2. Fitting material. 2. Die Keramikplatte umgedreht auf gepolsterten Montageböcken ablegen.
Seite 2
M8 x 65 3. Den Alu-Rahmen mit der Keramikplatte verbinden. 3. Connect the aluminum frame to the ceramic board. M8 x 20 4. Die Stahl-Platte abschrauben. 4. Unscrew the steel board. 2 / 6 1630 - 1633 Metallfuß, Frontauszug Änderungsdatum: 28.06.22...
Seite 3
6. Screw on the steel-board of the pre-assembled table base to the table top again. Please check the distance of the steel-plate to the end of the aluminium frame and adjust it if needed. 3 / 6 1630 - 1633 Metallfuß, Frontauszug Änderungsdatum: 28.06.22...
Seite 4
Markierungsbohrungen nutzen! 8. Screw on the plywood-plate of the pre- assembled table-base to the table top. The identification marking „M“ must be to the inner side. Use the making boreholes. 4 / 6 1630 - 1633 Metallfuß, Frontauszug Änderungsdatum: 28.06.22...
Seite 5
12. Check, if the ceramic-board is flush with the wooden extension. If not… 1. Slightly loosen the 6 fixing screws 2. Adjust the ceramic bord. 3. Tighten the 6 fixieren screws again. 5 / 6 1630 - 1633 Metallfuß, Frontauszug Änderungsdatum: 28.06.22...
Seite 6
13. Achtung, beim Einklappen immer die rechte Seite klappen und niemals die linke Seite klappen = Bruchgefahr!!! 13. Attention, always fold the right of the extension, never fold the left side = risk of breakage!!! 6 / 6 1630 - 1633 Metallfuß, Frontauszug Änderungsdatum: 28.06.22...