FLINQ FQC8197 Handbuch Seite 6

INSTRUCTIONS FOR USE AND MAINTENANCE:
When the product is installed in or to a tree, make sure that it is installed on stable and
maintained branches.
When disassembling, carefully remove the product from its location (trees, bushes, etc.) to
avoid any pressure on the Solar Light that could damage the component elements.
In case of non-use, store the product in a cool and dry place away from direct sunlight.
If snow is on top of the solar panel please remove it at all time's so the battery can be
charged correctly by the panel.
CAUTION:
• NON-Replaceable LED lights!
TROUBLESHOOTING TIPS IF THE LIGHT DOES NOT WORK:
Light does not turn on if something or someone moves into the detection range?
• The motion sensor is clean (if not, please clean it).
• The solar panel is clean (if not, please clean it).
• The solar cell was mounted so that it is able to receive as much as possible direct
sunlight during the day.
• The battery is sufficiently charged (if not, leave for 1~2 sunny days charging in the OFF
position).
Light flashes or low light?
• Weak battery: Let the lamp charge again for 1~2 sunny days (or 3~4 "Ordinary" days)
in the OFF position
.
For best results, you need to replace the battery every 24 months. Remove the battery
compartment cover on the back of the housing using a screw driver to remove the screws.
Delete the old battery. Make sure the new battery is rechargeable and is an 1x 3.7V
Li-Ion 2200 mAh rechargeable battery also available at www.flinqproducts.nl.
Install the new battery and take care of the proper connection. Close the battery