FLINQ FQC8197 Handbuch Seite 4

wall expansion plugs and screws.
• This lamp is intended only for outside use.
Ps. you can try other ways to install it depending on the actual condition. But do not keep the solar
panel upside down in anyway, otherwise it will affect the effect of solar charging at daylight.
NOTE:
If there's sunlight or other lights on the solar panel, the lamp will not be ON even if the
ON/OFF switch has been turned ON. During testing, other object (hand or arm) should be
used to cover the complete solar panel, then the lamp will be ON after turning on the
ON/OFF switch. Actual range of the motion detection sensor <8 meter depends on mounting
height as shown in the illustration.
OPERATION AND BUTTON MODE USE:
The solar lamp has 3 lighting modes, which can be selected using the ON/OFF button:
1. MODE 1: FULL LIGHT ON/OFF
Press the ON/OFF button 1x to select mode 1. The lamp will turn ON automatically
at night at full light (100%) when motion is detected in the detection range.
About 20 seconds after the last motion has been detected the lamp turns OFF.
2. MODE 2: FULL LIGHT + DIM ON
Press the ON/OFF button a 2nd time to select mode 2. The lamp will work the same as Mode
1 but after about 20 seconds after the last motion has been detected it turns to 15% of light
and keeps on working till the morning time or till the battery is empty.
3. MODE 3: DIM ONLY (NO MOTION SENSOR DETECTION)
Press the ON/OFF button a 3rd time to select mode 3. The lamp will turn ON automatically
at night with a dimmed light (15%) and keeps on working like that till the morning time or till
the battery is empty and the motion sensor is not working.
4. OFF
If you press the ON/OFF button again, the lamp is turned OFF completely. The