ekwb EK-Loop Bedienungsanleitung Seite 6

EAN: 3831109816103
EAN: 3831109816127
EAN: 3831109816110
FIG. 5
FIG. 6
- 6 -
We recommend using EK-Loop Modulus Hard
Tube Bending Tool for easier tube bending:
EK-Loop Modulus Hard Tube Bending
Tool – 12mm,
Product EAN: 3831109816103
ht tps://w w w.ek wb.com/shop/ek- lo op -
modulus-hard-tube-bending-tool-12mm
EK-Loop Modulus Hard Tube Bending
Tool – 14mm,
EAN: 3831109816127
Product EAN: 3831109816110
ht tps://w w w.ek wb.com/shop/ek- lo op -
modulus-hard-tube-bending-tool-14mm
EK-Loop Modulus Hard Tube Bending
Tool – 16mm,
Product EAN: 3831109816127
ht tps://w w w.ek wb.com/shop/ek- lo op -
modulus-hard-tube-bending-tool-16mm
WARNING
Always place a hot heat gun on a
level surface UPRIGHT (FIG.5)
Never place a heat gun lying on the side
(FIG.6)
WARNING: Read this manual
and general safety instructions
carefully
heat gun, for your own safety.
Your heat gun should only be
passed on together with these
instructions. The heat gun should
be connected only to a power
supply of the same voltage as
indicated on the nameplate, and
can only be operated on single-
phase AC supply.
WARNING (US plug): This heat
gun has a polarized plug (one
blade is wider than the other). To
reduce the risk of electric shock,
this plug is intended to fit in a
polarized outlet only one way. If
the plug does not fit fully in the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician. Do not modify the
plug in any way.
before using the