Setting The Temperature; Heat Gun Placement - ekwb EK-Loop Bedienungsanleitung

INCREASE THE
TEMPERATURE
MIN. DISTANCE
5 cm (2")
Select the required operating temperature
and air volume with switch position II. (FIG. 3)
EU plug (VDE) and UK plug (BS)
US plug (UL)
FIG. 3

SETTING THE TEMPERATURE

INTEGRATED
(FIG. 4) The temperature can be increased
DISPLAY
and decreased in intervals of 30°C (86°F) via
the control panel when the stage is I, and the
temperature can be increased and decreased
in intervals of 55°C (131°F) via the control panel
when the stage is II. To increase the temperature
press the left-hand button (+); to decrease
the temperature press the right-hand button
(-). Either tap the buttons briefly or press and
hold the buttons until the desired temperature
setting is reached. When doing this, please note
DECREASE THE
the maximum temperature, which depends on
TEMPERATURE
the on/off switch. The maximum temperature
is only possible in switching to stage 2. If
switching to stage 1 is selected, the maximum
temperature is 350 °C (662°F). The integrated
display shows the temperature rating by
FIG. 4
colored increments.

HEAT GUN PLACEMENT

Place the heat gun upright on level surface
(table) . Insert a silicone bending rod in a
tube. Silicone rod is used for smoother tube
bends. Hold a tube with inserted silicone
rod approximately 5 cm (2 inches) from
heat gun nozzle. Slowly rotate a tube along
the axis and move it from side to side to
heat the tube evenly. When tube is heated
you can bend it to required shape. If the
tube is heated for a long period, bubbles,
deformation of the pipe diameter, changed
color of the pipe may occur.
- 5 -
Switch position I:
I. Setting 60°C -350°C / 300 l/min
Switch position II:
II. Setting 60°C - 600°C / 500 l/min
Switching off:
Set the switch to 0. (FIG. 1)
Switch position I:
I. Setting 140°F - 572°F / ~11 cfm
Switch position II:
II. Setting 140°F - 932°F / ~18 cfm
Switching off:
Set the switch to 0. (FIG. 1)
-1
-1