Reset Procedure - HOMCOM 920-077V70 Montageanleitung

I. Reset Procedure
IMPORTANT: You must reset the desk prior the use.
Make sure no obstacles are in the desk's path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to accommodate the change in height.
RESET : In the "E10, E20, E60" alarm state or after running to the lowest altitude
position, press and hold the button
release, the lifting table starts to run down to the bottom and rebounds to a certain
height, and the reset completes to display the minimum height.
II. Up and down of the desk
Press and hold the
Press and hold the
digital ) can be seen on the LED screen display
Press and hold the
digital ) can be seen on the LED screen display
III. Function of memory height :
In the normal state, if you press the
on the LED display.if release the button, the desk will lift from
current height to the sitting position.
If you press the
release the button, the desk will lift from current height to the
standing position.
Ⅳ. Awake Extinguishing screen
To avoid misoperation, the LED display of manual control will go rest after some
time and no action by press any button .Please hold and press
seconds ,the LED display lights on .
button and button to control the desk up or down.
button to control the desk up , the increase in height (display
button to control the desk down,the decrease in height (display
button ，"H2" will be displayed on the LED display.if
for 3 seconds, display
button, "H1" will be displayed
-14-
(Reset) and
button several