To Clean The Product - Hard Head 791221 Bedienungsanleitung

12
Tighten the nuts for the expansion bolts again.
13
Remove the band from the awning.
4 Operation
Caution! Remove the crank handle and keep it dry
when the awning is not in use.
4.1 To set the angle of inclination
Warning! Do not turn the setting screws further than
the end position. This can cause serious personal injury and
damage the product.
Caution! Do not extend the product more than 1/4
before making the adjustment.
The recommended angle of 140 is set at the factory. The
angle of inclination can be set between 140–500 (A–B) if it is
necessary. (Figure 5)
1
Extend the product. Refer to "4.2 To operate the
product" on page 21.
2
Locate the coupling. (Figure 6)
3
Loosen the lock nuts (A). (Figure 7)
4
Turn the setting screw (B) clockwise to decrease the
angle and counterclockwise to increase the angle of
inclination.
5
Fasten the lock nuts.
6
Do the same adjustment on the opposite side.
4.2 To operate the product
Warning! Keep body parts and objects away from
moving parts when the product is extended or retracted -
risk of serious personal injury and damage to the product.
Caution! When the front rail touches the roller, do not
retract any further.
Caution! Retract the product in the case of strong
wind, rain, hail or snow.
1
Install the crank handle (A) into the loop (B).
(Figure 8)
2022_001
2
Turn the handle clockwise to extend and
counterclockwise to retract the product.
Note! Make sure that the fabric is stretched tightly.
(Figure 9–10)
5 Maintenance
5.1 To do maintenance on the product
Warning! Do not use the product if it is damaged.
● Make sure that the fixtures are securely attached. Tighten
them if they are loose.
● Inspect the gearbox every 6 months. If the gearbox is
damaged, it must be repaired or replaced before the
product is used again.
● Inspect all screw connections every 6 months. Tighten if
it is necessary.
● If the product is stiff or makes noises, lubricate the
moving parts.
Caution! Do not use a petroleum-based lubricant.
Caution! Make sure to not lubricate the textile.

5.2 To clean the product

Caution! Do not use abrasive or corrosive detergents
when you clean the product.
Caution! Do not dry the fabric with a hairdryer, fan or
similar devices.
● Clean the frame with a damp cloth and mild detergent.
● Clean the fabric every 6 months with warm water and
mild detergent. Let the fabric become dry.
6 Storage
● Make sure that the fabric is dry before the product is put
in storage.
● Put the product in a clean and dry place.
● Put the product out of reach of children.
● Put the band on the awning to make sure it does not
extend.
21