Installation Tools - Hard Head 791221 Bedienungsanleitung

● Do not install the product if any parts are missing or
damaged. Speak to an authorized service center.
● Keep children and pets at a suitable distance from the
working area during installation and/or when
adjustments are made.
● The product must be mounted on reinforced concrete or
solid brick walls or ceilings.
● If the building has a veneer wall or an outer shell, facing
bricks or a facing panel and additional insulation, the
installation must be done by a person with the necessary
knowledge.
● Do not attempt to change or modify the product without
permission from the manufacturer.
● Do not operate the product when the temperature is
below zero, this can damage the product.
● Do not operate the product when there is snow on it, this
can damage the product.
● Do not climb on the product.
● Do not hang any objects from the product.
● Extreme weather or other extreme conditions can
subject the expansion bolts to very strong forces. Do a
check of the strength of the wall and the intended fixture
points before installation.
● Speak to a person with the necessary knowledge if there
are cracks in the wall.
● Make sure that the wall or ceiling is flat so that the
fixtures can be securely fitted.
3 Installation

3.1 Installation tools

● Hammer drill
● 14 mm drill bit
● Spirit level
● 17 mm wrench
● Step ladder
● Tape measure
● Chalk or marker pen
3.2 To install the product
Warning! The installation requires at least 2 persons.
Warning! Do not drill into mortar joints. Mortar joints
20
are not strong enough to hold the product.
Caution! The minimum installation height is 2.5 m.
Measured from the front rail as the product is fully entended.
1
Select an installation place.
2
Measure the required position (B) and add 60 cm (A)
where the lower drill hole for the fixture will be when
the product is at a 140 angle. The total height is 3.1 m
(C). (Figure 2)
Note! If the product is installed above a balcony or a
window, add at least 20 cm space above the frame.
3
Mark a horizontal line at the correct height in the
selected area. Make sure that the line is level.
4
Measure and mark the position of the fixtures (D) on
the wall. (Figure 3)
Note! Make sure that the measurement (E) and (F) and (G)
corresponds to your product. Refer to "8.1 Measurements"
on page 22.
5
Hold a fixture with the lower fixture hole at the same
height as the line and mark the drill holes.
6
Drill 90 mm deep holes for the fixtures.
7
Remove the nuts and washers from the expansion
bolts.
8
Insert the expansion bolts.
Note! Make sure that the expansion bolts are fully fitted in
the holes.
9
Place the fixtures on the expansions bolts and install
the washers and the nuts. Tighten firmly.
10
Insert the awning into the fixtures. Make sure that the
distance between the fixtures and the couplings are
correct. Refer to "8.1 Measurements" on page 22.
(Figure 4)
Note! If the rectangular tube does not fit correctly in the
fixtures you can loosen the nuts for the expander bolts and
fit it again. Make sure to tighten the nuts.
11
Install the screws, washers and nuts to lock the
awning in place.
2022_001