Fuel Safety - Husqvarna BMP 265 Bedienungsanweisung

Extension cables
• Use only approved extension cables with sufficient
length.
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
Wheel brakes
The brake handle controls the wheel brakes. The brakes
are engaged when the brake handle is in neutral
position. The brakes are released when the brake
handle is pulled in the direction of the handle.
To do a check of the wheel brakes
1. Start the product. Refer to
page 10 .
2. Make sure that the product does not move. If the
product moves, adjust the brake pressure. Refer to
[xref].
Operator Presence Control (OPC) BMP 265
When the OPC is engaged, the motor stops. Refer to
do a check of the OPC BMP 265 on page 8 .
To do a check of the OPC BMP 265
1. Start the product. Refer to
page 10 .
8
Read the warning
To start the product on
To start the product on
2. Pull out the OPC, refer to
(OPC) BMP 265 on page 8 . If the motor does not
stop in 3 seconds, speak to an approved Husqvarna
service agent.
Emergency stop button BMP 265
The emergency stop button is used to quickly stop the
motor. The emergency stop button breaks the mains
power supply. Refer to
page 2 for information about where the emergency stop
button is on your product.
To do a check of the emergency stop button BMP 265
Product overview BMP 265 on page 2 for
Refer to
information about where the emergency stop button is
on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 10 .
3. Push the emergency stop button.
4. Make sure that the motor stops.
5. Turn the emergency stop button clockwise to
disengage.
Engine ON/OFF switch BMP 265Petrol
The engine can only start when the engine ON/OFF
switch is set to "ON". The engine stops when you set the
engine ON/OFF switch to "OFF".
To do a check of the engine ON/OFF switch
1. Start the engine. Refer to
page 10 .
2. Set the engine ON/OFF switch to "OFF". The engine
stops.
Side cover
The side cover keeps dust and particles away from the
operator.
To do a check of the side cover
• Make sure that the holes on the side cover are not
worn and that the screws are fully tightened.

Fuel safety

WARNING:
instructions that follow before you use the
product.
To
• Fuel is flammable and the fumes are explosive. Be
careful with fuel to prevent injury, fire and explosion.
• Do not breathe in the fuel fumes. The fuel fumes are
poisonous and can cause injury. Make sure that the
airflow is sufficient.
Operator Presence Control
Product overview BMP 265 on
To start the product on
To start the product on
Read the warning
1814 - 002 -