Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operations and Connectors
1. High Power Input Rear
2. Switch Low Pass Filter Rear
3. Switch Low Pass Filter Front
4. High Power Input Front
5. Adjust Low Pass Rear
6. Gain Rear
7. Low Power Input Rear
8. Low Power Input Front
9. Gain Front
10. Adjust Low Pass Front
Important Installation Information
This appliance may only be connected to a 12 volt system with negative ground.
•
Because of high power unit, using the unit while the engine is stopped may totally discharge the
•
battery, please run the engine in using the unit.
•
The heat radiated when the amplifier is used means that sufficient air circulation is requered at the
place of installation. It is very important that the cooler`s cooler ribs do not contact any metal plating or
any surfaces which could impair air circulation.
The amplifier may not be installed in small confined spaces or spaces without air circulation. Installation
•
in the boot is recommended.
•
Install the amplifier in such a way that it is protected as far as possible against vibrations and dust and
dirt.
Make sure that the input/output cables are sufficiently distant from the power supply cables as
•
otherwise interference may occur.
Make sure that the fuse and operating elements are accesible after installation.
•
•
The appliances reliability and performance depend on the quality of installation. Preferably get an expert
to install the system, particularly if you want to install several loudspeakers or a complex multi-way
system.
© Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
11. DC Input
12. Fuse
13. Speakers Front
14. Speakers Rear
751-181
Werbung
Inhaltsverzeichnis
