Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Mounting
Using a 38mm diameter hole saw, cut a hole through the roof and
ceiling for the centre shaft. Apply a layer of approx. 0,5 cm thick of
adhesive such as Sikaflex® on the bottom of the base plate. Follow the
manufacturer's guidelines for surface preparation, application and
curing.
Insert the crankshaft with square tube into the hole, then position and
attach the lift assembly to the roof with the enclosed self-cutting tapping
screw s.
Measure the thickness of the roof. Using the table below, decide if you
need one or two ceiling support plates. Assemble graduation disc,
ceiling plate, rotation handle, spring, washer and elevating handle (See
illustration). Slide all parts over shaft and tighten the screw in the
elevation handle.
Roof thickness
Up to 32mm
From 32 mm
From 50 mm
Direction of motion
Number of ceiling support plates
2
1
None
Lift assembly
Ceiling support plate
Graduation disc
Ceiling plate
Rotation handle
Spring
Washer
Elevation handle
Antenna
Werbung
