Herunterladen Inhalt Inhalt Diese Seite drucken

Installation In The Vehicle; Removing The Car Seat - URBAN KANGA WALLAROO Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20

5. Installation in the Vehicle

5.1 Stature 100-150cm | ISOFIX attachment + Vehicle 3-point seatbelt
Refer to page 15, fig.6 for the illustrations
5.1.1
Pull the ISOFIX attachment release button to extend the ISOFIX connectors.
5.1.2.
Push the ISOFIX connectors into the ISOFIX anchor points in the vehicle until you hear two clicks of "click".
Please check the red and green indicator on the ISOFIX connectors to ensure correct installation. RED
indicates incorrect installation and green indicates correct installation. Then pull the ISOFIX attachment
handle and push the seat inward to your desired recline angle.
5.1.3
Thread the vehicle safety belts through the belt guides ensuring that the seat belt is threaded through the
green shoulder belt guide and both (2) waist belt guides. Tighten the belt and ensure that the belts are
not twisted.
CAUTION! Ensure that the lap strap lap is worn low down, so that the pelvis is firmly engaged. Pull on the
strap until it lies flat and is close against your child's body.
The straps should be correctly adjusted and ensure they are not twisted.
5.2 Stature 100-150 cm | Vehicle 3 point seat belt only (without ISOFIX connector)
Refer to page 15, fig.7 for the illustrations
5.2.1
Place the child safety seat on the vehicle seat and push the it tightly against the back of the vehicle's
seat-back.
5.2.2
Thread the vehicle safety belts through the belt guides ensuring that the seat belt is threaded through the
green shoulder belt guide and both (2) waist belt guides. Tighten the belt and ensure that the belts are
not twisted.
CAUTION! Ensure that the lap strap lap is worn low down, so that the pelvis is firmly engaged. Pull on the
strap until it lies flat and is close against your child's body.
The straps should be correctly adjusted and ensure they are not twisted.

6. Removing the car seat

Refer to page 15, fig.8 for the illustrations
To release the ISOFIX connectors, pull the release button backwards and then the second release button
down to release the ISOFIX dual lock system.
Child Car Seat
EN
18
|
PAGE

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis