How To Set The Clock In Motion; How To Set The Time - Erwin Sattler Classica 60 Bedienungsanleitung

How to align the clock case
Align the clock case vertically, i.e. the tip of the pendulum has to point exactly to the middle
of the pendulum scale.

How to set the clock in motion

Wind up the clock one turn with the crank to the right.
Deflect the pendulum carefully and then let it go.
Should the clock tick irregularly you can correct it by slightly turning the adjusting screw
on the pallet fork, located down on the back of the clockwork.
Caution!
For perfect function:
When the weight has been hung in the rope pulley for the first time, let the clock go until
it runs down and the weight is totally down at the bottom of the case.
Only from this position you should wind up the clock completely for the first time. The following
times wind up the clock before the weight reach the bottom of the case.

How to set the time

In order to set the time the minute hand may be turned forwards as well as backwards.
How to adjust the clockwork
Your clock has been exactly adjusted in our workshop. The transport and the geographic height
of the place where the clock is hung up may however lead to a variation in the period of
oscillation of the pendulum. You will therefore most probably have to adjust your clock once
again.
Please proceed as follows:
Caution!
In order not to twist the pendulum spring hold the pendulum rod during adjustment with
one hand.
Then turn the adjusting nut on the lower end of the pendulum to the left when the clock
is fast, i.e. to the right when the clock is slow.
After having watched the accuracy a couple of days you may readjust the clock.
6