How To Hang In The Pendulum - Erwin Sattler Classica 60 Bedienungsanleitung

Mounting the clock on the wall
Choose for your clock a place without direct insolation on a stable wall and attach a stable
nail or screw to it, however by no means a hook. Please unpack the clock carefully (keep the
packing material for possible transports of the clock) and hang it on its predetermined place.
Caution!
With the clock, there is a protecting cover that has to be laid inside the bottom of the
case! The cover has to be used, to avoid damages of the case! Please remove the
cover only after the installation is complete!
How to take out the movement
The clockwork must be removed in order to insert the pendulum later.
Pull the leaf spring, located at the level of number »2« behind the dial, to the front and push
the clockwork upwards until the stop. Then take the clockwork forward out of the clock case
and put it carefully down on an even and firm underground with the dial downwards.

How to hang in the pendulum

Hang the pendulum carefully in the pendulum
spring without bending the spring.
How to fit the movement
Place the clockwork onto the four pillars, press
it backwards and push it down. In so doing
please pay attention to the impulse pin for the
Slot for
pendulum locks in the slot of the plate on the
pendulum rod (see fig. right).
the impulse pin
Then hang the weight in the rope pulley
without bending the cat-gut.
5