Notes: After adjusting the grinding, the adjustment will persist
from the third cup of coffee onwards.
Warnings shown on the LED display
Insufficient water - add water to the tank (1) (fig. 15).
No brewing unit - make sure that the brewing unit (9) is posi-
tioned correctly and properly secured (fig. 16).
Used coffee grounds container - make sure that the used cof-
fee grounds container (12) is positioned correctly (fig. 17).
Close the compartment - close the side shutter of the brewing
unit (10) (fig. 18).
Insufficient coffee beans - add coffee beans into the coffee
beans container (2) (fig. 19).
Full container, cleaning required - empty the Container (12)
(fig. 20).
Clogged tube - switch the Coffee Machine off and make sure
that the water tank is full, then switch the Coffee Machine back
on. If the problem persists, contact the support hotline for pro-
fessional help (fig. 21).
No drip tray - make sure that the drip tray (7) is positioned cor-
rectly (fig. 22).
CLEANING
– Clean the Coffee Machine with a slightly moist, soft tissue,
then wipe it dry.
– Do not use metal brushes or abrasives to clean the Coffee
Machine.
– Do not immerse the power cord, power plug, or Coffee
Machine body into water or other liquids.
– Wash the removable parts of the Coffee Machine (1, 7, 9, 11,
12) with warm water and neutral detergent, rinse them and dry.
Brewing unit cleaning and maintenance
Perform cleaning of the brewing unit (9) no less than once every
two weeks.
Attention! Do not remove the brewing unit while the Machine
is switched on.
Unplug the Coffee Machine from the mains. Open the shutter (10)
on the side and remove the used coffee grounds container (12)
(fig. 23). Empty the container off the used coffee grounds and its
residue. Wash it and dry.
Gently pull the brewing unit (9) handle, while holding down the
plastic bump. Extract the brewing unit (fig. 24).
Do not use abrasives that can damage the brewing unit (9) to
clean it.
Immerse the Brewing Unit into water for 5 minutes and wash it
under a stream of water.
Use the cleaning brush to remove the remaining coffee residue
from the brewing unit.
Cleaning the brewing unit using cleaning tablets
If the words «Add tablets to clean the unit» appear on the display
(fig. 6), add the detergent through the ground coffee funnel (8),
and press the «Menu» button (17) to continue.
Drip tray and grate (7)
Remove the grate from the tray (7), remove the tray and drain it
off the water, wash the tray and install it back into its place, install
the grate over the tray (7).
Water tank (1)
Perform a regular cleaning of the water tank (1) (approximately 2
times per month) using a moist tissue and soft detergent.
STORAGE
– Before taking the unit away for storage, unplug it and let the
unit cool down completely.
– Perform a cleaning of the unit as described in the «Cleaning»
section.
– Do not leave or keep the Coffee Machine in places with tem-
perature below 0°C.
– Keep the unit in a dry cool place, unreachable by children or
handicapped persons.
DELIVERY SET
Coffee Machine – 1 pc.
Coffee dust cleaning brush – 1 pc.
Power cable – 1 pc.
Manual – 1 pc.
Warranty certificate – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220-240 V ~ 50 Hz
Rated input power: 1200-1450 W
Water tank capacity: 2 L
RECYCLING
For environment protection do not throw out the unit and the bat-
teries (if included), do not discard the unit and the batteries with
usual household waste after the service life expiration; apply to
specialized centers for further recycling.
The waste generated during the disposal of the unit is subject
to mandatory collection and consequent disposal in the pre-
scribed manner.
9
ENGLISH